LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 958 (Engine Mechanical - 3.6L - Repair Instructions - Off Vehicle (2 Of 3)) >> Repair Instructions - Off Vehicle (2 Of 3) >> Cylinder Head Installation - Right Side >> Installation

Cylinder Head Installation - Right Side: Installation

WARNING: This page is about a different car, the 2010 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.
    2. Fig 1: View Of Cylinder Head Gasket
    GM902817Courtesy of GENERAL MOTORS CORP.
  2. Install a NEW right cylinder head gasket using the deck face locating pins for retention.
    3. Fig 2: View Of Right Cylinder Head
    GM902818Courtesy of GENERAL MOTORS CORP.
  3. Align the right cylinder head with the deck face locating pins.
  4. Place the right cylinder head in position on the deck face.
    5. Fig 3: Identifying Cylinder Head Bolt Tightening Sequence
    GM2126651Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
    NOTE: DO NOT allow oil on the cylinder head bolt bosses.
    NOTE: DO NOT reuse the old cylinder head bolts.
  5. Install the NEW M11 cylinder head bolts (1) and tighten.
    1. The M11 cylinder head bolts a first pass in sequence to 30 N.m (22 lb ft) .
    2. The M11 cylinder head bolts a second pass in sequence an additional 150 degrees using the J 45059:  meter .
  6. Install the NEW M8 cylinder head bolt (2) and tighten.
    1. The M8 cylinder head bolt a first pass to 15 N.m (11 lb ft) .
    2. The M8 cylinder head bolt a second pass an additional 75 degrees using the J 45059:  meter .
scientia non olet · About LEMON Manuals