LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shifter Assembly
    GM291888Courtesy of GENERAL MOTORS CORP.
  1. Spread the console side panels apart and install the shift control assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Install the shifter fasteners.

    Tighten:  Tighten the shifter fasteners to 9 N.m (79 lb in).

  3. Connect the shifter assembly electrical wire harness connector.
    4. Fig 2: View Of Transaxle Range Selector Cable
    GM1964445Courtesy of GENERAL MOTORS CORP.
  4. Install the transmission range selector cable (1) to the shift control base.
  5. Install the transmission range selector cable terminal (2) to the shift control pin.
  6. Install the console trim plate. Refer to Front Floor Console Trim Plate Replacement .
  7. Adjust the automatic transmission range selector cable. Refer to Range Selector Lever Cable Adjustment .
scientia non olet · About LEMON Manuals