Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Pedal & Stop Lamp Switch

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: When installing the torque converter clutch/cruise control release switch, ensure that the brake pedal remains in the full up or at rest position.

Connect the upper switch (1) electrical connector.
Install the upper switch (1) into the upper retainer.
Rotate the switch clockwise until fully seated.
Adjust the switch. Refer to Torque Converter Clutch/Cruise Control Release Switch Adjustment .
Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .