Inflatable Restraint Passenger Presence System Replacement - Front

WARNING: This page is about a different car, the 2007 Saturn Sky. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Passenger Presence System - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to Seat Replacement . Remove the seat cushion cover. Refer to Seat Cushion Trim Cover and Pad Replacement .
1	Inflatable Restraint Front Passenger Presence System Assembly CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. CAUTION: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction. Procedures Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup . Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .

Callout

Component Name

Preliminary Procedure

Remove the front seat. Refer to Seat Replacement .
Remove the seat cushion cover. Refer to Seat Cushion Trim Cover and Pad Replacement .

Inflatable Restraint Front Passenger Presence System Assembly

CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

CAUTION: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.

Procedures

Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .