Seat Cushion Trim Cover and Pad Replacement

WARNING: This page is about a different car, the 2007 Saturn Sky. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Cushion Trim Cover & Pad Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly. Preliminary Procedures: Remove the front seat. Refer to Seat Replacement .
1	Seat Back Recliner Nut NOTE: Refer to Fastener Notice . Tighten: 9 N.m (80 lb in)
2	Seat Cushion Cover Retainer (Qty: 4) Tip: Use a J 38778 Door Trim Pad Clip Remover to aid in the removal of the seat cushion cover retainers. See Special Tools .
3	Seat Cushion Cover Procedure Tilt the seat back forward. Disconnect the seat cushion cover J-channel from the seat cushion frame. Disconnect the electrical connector if working on the passenger seat.
4	Seat Cushion Pad Tip: The passenger presence system is part of the pad on the passenger seat cushion, and must be replaced as an assembly. If working on the passenger seat, re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .