Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Front Cover

Courtesy of GENERAL MOTORS CORP.

Install the engine front cover. Refer to Engine Front Cover Assemble .

Fig 2: View Of Water Pump

Courtesy of GENERAL MOTORS CORP.

Install the water pump. Refer to Water Pump Replacement (LY7) .
Install the camshaft covers.
- For the left camshaft cover, refer to Valve Rocker Arm Replacement - Left .
- For the right camshaft cover, refer to Valve Rocker Arm Replacement - Right .
Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement .

Fig 3: View Of Crankshaft Balancer

Courtesy of GENERAL MOTORS CORP.

Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .

Fig 4: Identifying Coolant Recovery Reservoir

Courtesy of GENERAL MOTORS CORP.

Install the coolant overflow reservoir. Refer to Coolant Recovery Reservoir Replacement .

Fig 5: Locating Power Steering Reservoir Mounting Stud Bolt

Courtesy of GENERAL MOTORS CORP.

Install the power steering reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement .
Install the upper radiator hose. Refer to Radiator Hose Replacement - Inlet (3.6L) .

Fig 6: View Of Generator Bolts

Courtesy of GENERAL MOTORS CORP.

Install the generator assembly. Refer to Generator Replacement (LY7) .
Install engine splash shield. Refer to Splash Shield Replacement - Engine .

Fig 7: View Of ECM Bolts

Courtesy of GENERAL MOTORS CORP.

Install the ECU module. Refer to Engine Control Module (ECM) Replacement .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (LY7) .