Test Description
The number below refers to the step number on the diagnostic table.
- 2: This step determines if the malfunction is caused by a battery overcharge condition.
Air Bag Indicator Always On
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: SIR Schematics | ||||
| 1 | Did you perform the Diagnostic System Check - SIR? | - | Go to Step 2 | Go to Diagnostic System Check - SIR |
| 2 |
|
7-17 Ω | Go to Step 5 | Go to Step 3 |
| 3 | Test the air bag indicator control circuit for a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
5.5-6.5 Ω | Go to Step 5 | Go to Step 4 |
| 4 | Replace the SDM. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement . Did you complete the replacement? |
- | Go to Step 5 | - |
| 5 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |