LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Automatic Transaxle - AISIN 81-40LE - DTC P1701 To DTC P2770 & U Series) >> DTC U0401 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Values Yes No
Schematic Reference: Automatic Transmission Controls Schematics (Hatchback) or Automatic Transmission Controls Schematics (Notchback)
Connector End View Reference: Connector End Views (Notchback) or Connector End Views (Hatchback)
1 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Save the DTC and Freeze Frame information into the scan tool memory.
  4. Perform the scan tool Clear DTC Information function for the transmission control module (TCM) and the engine control module (ECM).
  5. Operate the vehicle for 1 minute or until the malfunction indicator lamp (MIL) illuminates.
  6. Check the TCM for DTCs.
Is the MIL ON?		 - Go to Step 2  Go to Step 6 
2 
  1. Select request DTC status from the Diagnostic Trouble Codes Information menu.
  2. Request DTC by status.
Is DTC U0401 displayed?		 - Go to Step 3  Go to Step 6 
3 
  1. Turn OFF the ignition.
  2. Disconnect connector A from the TCM.
  3. Turn the ignition ON, with the engine OFF.
  4. Measure the resistance between terminal A17 of the TCM wiring connector and terminal K14 of the ECM wiring connector.
  5. Measure the resistance between terminal A7 of the TCM wiring connector and terminal K15 of the ECM wiring connector.
Was the resistance the specified value for both circuits?		 0 Ω Go to Step 5  Go to Step 4 
4  Inspect for poor connections at the harness connector of the ECM and/or TCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you correct the condition?		 - System OK -
5 
  1. Turn the ignition ON, engine OFF.
  2. Measure the voltage of terminal A17 of the TCM.
  3. Measure the voltage of terminal A7 of the TCM.
Is the voltage within the values shown?		 1.5-3 V Go to Step 6  Go to Step 7 
6  Repair the terminals or the wiring connectors for intermittent failure, as necessary.
Is the action complete?		 - System OK -
7 
  1. Replace the TCM. Refer to Transmission Control Module Replacement .
  2. Turn the ignition OFF.
  3. Turn the ignition ON.
  4. Check if DTC U0401 is set.
Did the DTC reset?		 - Go to Step 8  Go to Step 9 
8  Replace the ECM. Refer to the following:
Did you complete the replacement?		 - Go to Step 9  -
9 
  1. Use the scan tool in order to clear the DTCs.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC.
Does the DTC reset?		 - Go to Step 1  System OK
scientia non olet · About LEMON Manuals