LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Impala Police >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Engine Mechanical - 3.4L V6 - VIN (E) (La1)) >> Repair Instructions >> On-Vehicle Repair instructions >> Engine Mount Bracket Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Remove the throttle body air inlet duct.
  3. Remove the engine mount struts. Refer to Engine Mount Strut Replacement - Left  and to Engine Mount Strut Replacement - Right .
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Remove the three-way catalytic converter pipe from the right exhaust manifold. Refer to Catalytic Converter Replacement (3.4L) in Engine Exhaust.
  6. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Remove the right engine splash shield. Refer to Splash Shield Replacement - Engine - Right in Body Front End.
    8. Fig 1: Engine Mount, Engine Mount Bracket & Bolts
    GM96007Courtesy of GENERAL MOTORS CORP.
  8. Remove the bolts which secure the engine mount bracket to the oil pan.
  9. Install the engine support fixture. Refer to Engine Support Fixture .
  10. Raise the engine.
    11. Fig 2: Identifying Engine Mount Upper Nuts
    GM96010Courtesy of GENERAL MOTORS CORP.
  11. Remove the engine mount upper nuts.
  12. Remove the engine mount bracket from the engine mount.
scientia non olet · About LEMON Manuals