Linear Shift Assembly - Assemble - Off Vehicle (Column Shift)

Install the linear shift assembly onto the steering column support assembly.
NOTE: Refer to FASTENER NOTICE .
Secure the linear shift assembly to the steering column assembly with the 3 flat head tapping screws.
Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.

Tighten

Tighten the 3 TORX® screws to 10 N.m (89 lb in).

Fig 1: Installing Linear Shift Assembly & Screws (Column Shift)
Courtesy of GENERAL MOTORS CORP.
Install the automatic transmission shift lock control.
Install the shift lever clevis and put the column in the neutral position.
The neutral position is 2 positions from the park position.

Fig 2: Installing Automatic Transmission Shift Lock Control (Column Shift)
Courtesy of GENERAL MOTORS CORP.
Slide the park position switch assembly onto the linear shift assembly.
Connect the automatic transmission shift lock control connector onto the park position switch assembly.

Fig 3: Installing Park Position Switch Assembly (Column Shift)
Courtesy of GENERAL MOTORS CORP.
Connect the park lock cable assembly (1) to the lock module assembly in the following way:
1. 8.1. Place the steering column lock cylinder set into the off position.
2. 8.2. Place the shift lever clevis into the park position.
3. 8.3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly.
Install the shift lever. Refer to Shift Lever Replacement - On Vehicle .
Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift Snap On Shrouds) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .
Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .

Fig 4: Connecting Park Lock Cable Assembly (Column Shift)
Courtesy of GENERAL MOTORS CORP.