LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 689 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Route the wiring through the steering wheel.
  2. Align the mark on the steering wheel with the mark on the shaft.
  3. Install the steering wheel.
    CAUTION: Refer to FASTENER NOTICE .
  4. Install the steering wheel retaining nut.

    Tighten 

    Tighten the steering wheel retaining nut to 41 N.m (30 lb ft).

    Fig 1: Installing Steering Wheel Retaining Nut
    G01581849Courtesy of GENERAL MOTORS CORP.
  5. Install the mass damper.
  6. Install the mass damper retaining screw.

    Tighten 

    Tighten the mass damper retaining screws to 3 N.m (27 lb in).

    7. Fig 2: Installing Steering Wheel Mass Damper
    G01581850Courtesy of GENERAL MOTORS CORP.
  7. Install the inflatable restraint steering wheel module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) .
  8. Enable the SIR system. Refer to ACTIVATING SYSTEM .
scientia non olet · About LEMON Manuals