LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 687 (Power Seat System) >> Repair Instructions >> Heated Seat Switch Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Heated Seat Switch
    GM752597Courtesy of GENERAL MOTORS CORP.
  1. Install the switch to the console panel.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the retaining screw.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

  3. Connect the electrical connector.
  4. Install the center console end panel. Refer to CENTER CONSOLE END PANEL REPLACEMENT .
scientia non olet · About LEMON Manuals