LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Switch Housing - Disassemble - Off Vehicle (Standard)

Turn Signal Switch Housing - Disassemble - Off Vehicle (Standard)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM in SIR.
  2. Remove the turn signal cancel cam and upper bearing thrust. Refer to Turn Signal Cancel Cam and Bearing Thrust Washer - Disassemble - Off Vehicle .
  3. Remove the turn signal and multifunction switch assembly only. Refer to Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle .
  4. Slide the turn signal switch housing off of the steering column shaft assembly.
    Fig 1: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly
    GM664269Courtesy of GENERAL MOTORS CORP.