LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Steering Column Upper Support Bracket Nuts
    GM374713Courtesy of GENERAL MOTORS CORP.
    CAUTION: In order to ensure the intended function of the steering column in a vehicle during a crash and in order to avoid personal injury to the driver, perform the following:
    • Tighten the steering column lower fasteners before you tighten the steering column upper fasteners. Failure to do this can damage the steering column.
    • Tighten the steering column fasteners to the specified torque. Overtightening the upper steering column fasteners could affect the steering column collapse.
  1. Install the steering column to the vehicle.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the nuts to upper support brackets.

    Tighten:  Tighten the nuts to 30 N.m (22 lb ft).

    3. Fig 2: Knee Bolster Deflector Bracket Nuts
    GM748879Courtesy of GENERAL MOTORS CORP.
  3. Install the nuts (1) retaining the knee bolster deflector to the instrument panel.

    Tighten:  Tighten the retaining nuts to 9 N.m (80 lb in).

    4. Fig 3: Wiring Harness-To-Insturment Panel Retaining Pin
    GM748881Courtesy of GENERAL MOTORS CORP.
  4. Install the wiring harness retaining (4) pin to the instrument panel.
    5. Fig 4: View Of Steering Column Electrical Connectors
    GM401496Courtesy of GENERAL MOTORS CORP.
  5. Connect the steering column electrical connectors to the vehicle wiring harness.

    Tighten:  Tighten the steering column bulkhead connector to 6 N.m (53 lb in).

    6. Fig 5: Transmission Shift Cable To The Steering Column
    GM748882Courtesy of GENERAL MOTORS CORP.
  6. Connect the transmission shift cable (1) to the steering column.
  7. Install the body control module bracket. Refer to BODY CONTROL MODULE REPLACEMENT in Body Control System.
  8. Install the knee bolster. Refer to KNEE BOLSTER REPLACEMENT (NON-LUXURY) or KNEE BOLSTER REPLACEMENT (LUXURY) in Instrument Panel, Gages, and Console.
  9. Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
    10. Fig 6: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  10. Remove the J 42640  from the steering column.
scientia non olet · About LEMON Manuals