LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement - On Vehicle (With Tow/Haul Switch) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Seal On The Shift Lever And TORX Head Shift Lever Screw (With Tow/Haul Switch)
    GM362445Courtesy of GENERAL MOTORS CORP.
  1. Install the shift lever (1).
  2. Connect the shifter electrical connector.
  3. Install the wire straps to the harness.
    4. Fig 2: Wiring Harness-To-Insturment Panel Retaining Pin
    GM748881Courtesy of GENERAL MOTORS CORP.
  4. Install the harness retaining pin (4) to the instrument panel.
    5. NOTE: Refer to FASTENER NOTICE .
    Fig 3: Knee Bolster Deflector Bracket Nuts
    GM748879Courtesy of GENERAL MOTORS CORP.
  5. Install the knee bolster deflector bracket and nuts (1).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  6. Install the knee bolster. Refer to KNEE BOLSTER REPLACEMENT (NON-LUXURY) or KNEE BOLSTER REPLACEMENT (LUXURY) in Instrument Panel, Gages and Console.
  7. Install the TORX® head screw.

    Tighten:  Tighten the screw to 1.5 N.m (13 lb in).

  8. Roll the seal over the TORX® head screw.
  9. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement - On Vehicle .
scientia non olet · About LEMON Manuals