LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Ignition Switch Replacement - On Vehicle >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Switch & Lock Module
    GM389639Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition switch (3) to the lock module (1).
    2. Fig 2: Identifying Key Alarm Connector At Ignition Lock Cylinder Case
    GM306267Courtesy of GENERAL MOTORS CORP.
  2. Install the key alarm connector (1) into the lock module assembly (2).
    1. Push the key alarm connector (1) into the lock module assembly (2).
    2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
  3. Install the passkey connector into the lock module assembly (2).
    4. Fig 3: Electric Park Lock & Connector
    GM389654Courtesy of GENERAL MOTORS CORP.
  4. Install the connector (2) to the electric park lock (1), for vehicles equipped with floor shifters.
    5. Fig 4: Turn Signal & Multifunction Switch Assembly Connectors
    GM306234Courtesy of GENERAL MOTORS CORP.
  5. Slide the 2 connectors (2) of the turn signal and multifunction switch into the bulkhead connector (1).
    6. Fig 5: View Of Steering Column Wire Harness Assembly & Wire Harness Strap
    GM415293Courtesy of GENERAL MOTORS CORP.
  6. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
    7. Fig 6: View Of Steering Column Electrical Connectors
    GM401496Courtesy of GENERAL MOTORS CORP.
  7. Connect the steering column electrical connectors to the vehicle.
  8. Install the trim covers to the column. Refer to Steering Column Trim Covers Replacement - On Vehicle .
  9. Install the knee bolster. Refer to KNEE BOLSTER REPLACEMENT (NON-LUXURY) or KNEE BOLSTER REPLACEMENT (LUXURY) in Instrument, Panel, Gauges and Console.
  10. Enable the SIR system. Refer to ACTIVATING SYSTEM in SIR.
  11. It may be necessary to reprogram the theft deterrent system if the module was replaced. Refer to PROGRAMMING THEFT DETERRENT SYSTEM COMPONENTS in Theft Deterrent.
scientia non olet · About LEMON Manuals