LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Steering Wheel & Steering Column) >> Repair Instructions >> Electronic Column Lock Module - Disassemble - Off Vehicle >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR CAUTION in Cautions and Notices.
  1. Disable the SIR system. Refer to DISABLING SYSTEM in SIR.
  2. Remove the ignition switch. Refer to Ignition and Key Alarm Switch Assembly - Disassemble - Off Vehicle .
  3. Remove the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Bearing Thrust Washer - Disassemble - Off Vehicle .
  4. Remove the park lock cable from the lock cylinder housing.
    5. Fig 1: View Of Lock Cylinder Housing TORX Screws
    GM1413838Courtesy of GENERAL MOTORS CORP.
  5. Remove 3 TORX® screws.
  6. Remove the lock cylinder housing from the steering column.
scientia non olet · About LEMON Manuals