LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Interior Trim) >> Repair Instructions >> Carpet Replacement - Front (Utility) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front seats. Refer to SEAT REPLACEMENT - FRONT BUCKET .
  2. Remove the rear seats. Refer to SEAT REPLACEMENT - REAR (60/40 SPLIT) or SEAT REPLACEMENT - REAR (50/50 SPLIT 2ND REAR) .
  3. Remove the front center seat. Refer to SEAT REPLACEMENT - CENTER .
  4. Remove the floor center console, if equipped. Refer to CONSOLE REPLACEMENT (BASE CONSOLE) or CONSOLE REPLACEMENT (LUXURY CONSOLE) .
  5. Remove the lower bracket from the I/P to the floor to allow carpet removal.
  6. Remove the door sill trim plates. Refer to Door Sill Plate Replacement - Front  and to Door Sill Plate Replacement - Rear  .
  7. Remove the hinge pillar trim panels from both sides. Refer to Trim Panel Replacement - Hinge Pillar  .
  8. Remove the garnish molding center pillar trim. Refer to Garnish Molding Replacement - Center Pillar  .
    9. Fig 1: Removing Front Carpet (Utility)
    GM625225Courtesy of GENERAL MOTORS CORP.
  9. Remove the carpet.
scientia non olet · About LEMON Manuals