Removal Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Remove the I/P cluster trim bezel. Refer to BEZEL REPLACEMENT - IP CLUSTER .

Fig 1: Wiper/Washer Switch Assembly

Courtesy of GENERAL MOTORS CORP.

Insert a flat bladed tool at the top and bottom of the switch assembly as shown in the graphic in order to pry it out.
Pull out the switch assembly in order to gain access to the connector.
Disconnect the wire connector.
Remove the switch from the I/P.
The rear wiper switch (1) is replaced as an assembly if the vehicle is equipped with front fog lamps.