LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 648 (Instrument Panel, Gauges & Console) >> Repair Instructions >> Knee Bolster Replacement (Non-Luxury) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Snap the top of the knee bolster into the IP assembly.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the knee bolster screws. Tighten the screws to 2 N.m (18 lbs in).
  3. Install the IP cluster trim plate bezel. Refer to Bezel Replacement - IP Cluster .
    4. Fig 1: Installing Knee Bolster Screws (Non-Luxury)
    G01697229Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals