LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 622 (Steering Wheel & Steering Column) >> Repair Instructions >> Turn Signal Switch Housing - Assemble - Off Vehicle

Turn Signal Switch Housing - Assemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Chevrolet Monte Carlo and 2002 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Important:  The signal switch housing assembly must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly screws to line up.

  1. Slide the signal switch housing assembly onto the steering column shaft assembly.
  2. Install the turn signal and multifunction switch assembly only. Refer to Turn Signal & Multifunction Switch Assembly - Assemble - Off Vehicle .
  3. Install the steering column tilt head components. Refer to Steering Column Tilt Head Housing - Off Vehicle .
  4. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals