LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Installation

Rear Disc Brake Backing Plate: Installation

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate to the axle housing flange.
  2. Install the backing plate nuts. Tighten the backing plate bolts. See TORQUE SPECIFICATIONS  .
  3. Install the rear drive axle. See REAR AXLE SHAFT REPLACEMENT in appropriate REAR DRIVE AXLE article.
  4. Install the park brake shoe.
  5. Install the rear brake rotor.
  6. Install the brake caliper and bracket assembly. See REAR DISC BRAKE HARDWARE  .
  7. Install the park brake cable to the rear brake caliper. See PARK BRAKE CABLE  .
  8. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS.
  9. Install the tire and wheel assembly. Lower the vehicle.
scientia non olet · About LEMON Manuals