Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle (Floor Shift)

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
Tighten:

Tighten the 2 pan head tapping screws to 7 N.m (62 lb in)

Fig 1: Turn Signal And Multifunction Switch Assembly
Courtesy of GENERAL MOTORS CORP.
Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
Reconnect the turn signal and multifunction switch assembly connector to the inflatable restraint steering wheel module coil connector.

Fig 2: Turn Signal And Multifunction Switch Assembly Connectors
Courtesy of GENERAL MOTORS CORP.
Attach the wire harness assembly (1) to the steering column with new wire harness strap (2).

Fig 3: Wire Harness Assembly

Courtesy of GENERAL MOTORS CORP.

Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .