Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle (Column Shift)

WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Install the ignition and key alarm switch assembly (1) onto the electronic lock module assembly.
Screw the 2 tapping screws (2) into the ignition and key alarm switch assembly (1).
Tighten:

Tighten the 2 tapping screws to 1.5 N.m (13 lb in)

Fig 1: Tapping Screws To The Ignition And Key Alarm Switch Assembly
Courtesy of GENERAL MOTORS CORP.
Install the key alarm connector (1) into the electronic lock module assembly (2).
1. 3.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
2. 3.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
  
  Fig 2: Key Alarm Connector To The Electronic Lock Module Assembly
  Courtesy of GENERAL MOTORS CORP.
Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).

Fig 3: Turn Signal And Multifunction Switch Assembly Connectors
Courtesy of GENERAL MOTORS CORP.
Attach the wire harness strap (2) to the wire harness assembly (1) and the steering column.

Fig 4: Wire Harness Assembly
Courtesy of GENERAL MOTORS CORP.
Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) .