Trim Height Measurements
WARNING: This page is about a different car, the 2002 Buick Regal and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
Trim height is a predetermined measurement relating to vehicle ride height. Incorrect trim heights can cause bottoming out over bumps, damage to the suspension components and symptoms similar to wheel alignment problems. Check the trim heights when diagnosing suspension concerns and before checking the wheel alignment.
Perform the following before measuring the trim heights:
- Set the tire pressures to the pressure shown on the certification label.
- Check the fuel level. Add additional weight if necessary to simulate a full tank.
- Make sure the rear compartment is empty except for the spare tire.
- Make sure the vehicle is on a level surface, such as an alignment rack.
- Close the doors.
- Close the hood.
- All dimensions are measured vertical to the ground. Trim heights should be within 13 mm (0.5 in) to be considered correct. See TRIM HEIGHT SPECIFICATIONS .