LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 580 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new GM original equipment parts. Installation of used parts or non-GM original equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle handling and loss of vehicle control resulting in personal injury.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel.
  3. For front wheel drive vehicles, remove the rear brake drum. Refer to Brake Drum Replacement in Drum Brakes . For all wheel drive vehicles, remove the rear brake rotor. Refer to Brake Rotor Replacement - Rear in Disc Drakes .
  4. Use J 35917 in order to press the wheel stud from the wheel bearing/hub. See SPECIAL TOOLS .
scientia non olet · About LEMON Manuals