LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 553 (Fwd Axle Shafts) >> Removal & Installation >> Intermediate Shaft >> Installation >> Clip Installation Note

Clip Installation Note

WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new clip onto the intermediate shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on installation. For correct specification, see CLIP OUTER DIAMETER SPECIFICATION  table. For clip illustration, see Figure .
  2. After installation, measure the outer diameter. If it exceeds the specification, repeat procedure using a new clip.
scientia non olet · About LEMON Manuals