Clip Installation Note
WARNING: This page is about a different car, the 2004 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new axle shaft clip to the clip groove at the end of the axle shaft with the clip opening facing upward and the clip width within the specification. For correct specification, see CLIP OUTER DIAMETER SPECIFICATION table. For clip illustration, see Fig 1 .
- After installation, measure the outer diameter. If it exceeds the specification, repeat installation using a new clip.
CLIP OUTER DIAMETER SPECIFICATION
| Application | In. (mm) | |
|---|---|---|
| 2.0L | ||
| Automatic Transaxle | 1.16 (29.5) | |
| Manual Transaxle | 1.23 (31.2) | |
| 2.3L | 1.23 (31.2) | |