LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Wheel Cylinders >> Installation

Wheel Cylinders: Installation

WARNING: This page is about a different car, the 2002 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply LOCTITE(R) GM P/N 12345382, or equivalent, to the wheel cylinder shoulder face that contacts the backing plate. Position the wheel cylinder to the backing plate.
  2. Install the wheel cylinder mounting bolts. Tighten the wheel cylinder mounting bolts to specification. See TORQUE SPECIFICATIONS  .
  3. Remove the plugs from the brake pipe ends. Connect the brake pipe fitting to the wheel cylinder. Tighten the fitting to specification. See TORQUE SPECIFICATIONS  .
  4. Install the bleeder valve. Tighten the valve to specification. See TORQUE SPECIFICATIONS  .
  5. Install the brake shoes. See REAR BRAKE SHOES  . Adjust the drum brakes. See DRUM BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS. Install the brake drum. See REAR BRAKE DRUM  . Bleed the brake hydraulic system. See BLEEDING BRAKE SYSTEM  . Adjust the parking brake. See PARKING BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS.
  6. Install the tire and wheel assembly. Lower the vehicle.
scientia non olet · About LEMON Manuals