LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Installation

Rear Disc Brake Backing Plate: Installation

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate to the rear axle housing flange.
  2. Install the backing plate nuts. Tighten the backing plate bolts. See TORQUE SPECIFICATIONS  .
  3. Install the rear drive axle. See appropriate REAR DRIVE AXLE article in DRIVELINE/AXLES.
  4. Install the park brake shoe. See PARK BRAKE SHOE  .
  5. Install the rear brake rotor. See BRAKE ROTORS  .
  6. Install the brake caliper and bracket assembly. See BRAKE CALIPER BRACKETS  .
  7. Install the park brake cable to the rear brake caliper. See PARK BRAKE CABLE  .
  8. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS.
  9. Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS  . Lower the vehicle.
scientia non olet · About LEMON Manuals