LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 495 (Disc Brakes & Drum Brakes) >> Adjustments & Inspections >> Park Brake System >> Park Brake Adjustment

Park Brake Adjustment

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear brake rotor. See BRAKE ROTORS  under REMOVAL & INSTALLATION.
  2. Adjust the Drum-to-Brake Shoe Clearance Gage until it contacts the inside diameter of the rotor.
  3. Position the shoe clearance gage over the park shoe lining, left side shown, at the widest point.
  4. Turn the adjuster nut until the lining just contacts the shoe clearance gage.
  5. Repeat steps  1 - 3 to adjust the right rear park brake.
  6. The clearance between the rear park brake shoe lining and the rotor should be .026" (0.66 mm).
  7. Install the rear brake rotor. See BRAKE ROTORS  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals