LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 471 (Automatic Transmission - Overhaul - ALLISON) >> Transmission Reassembly >> Output Nut Installation

Output Nut Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, 2003 Chevrolet Cab & Chassis Silverado, and 2002 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure applies only to 1000 series 4WD transmissions.
  1. Using a wrench on selector shaft flats, rotate shaft to fullest clockwise position. See Figure. Ensure park pawl is engaged.
  2. Install Spanner Nut Wrench (J-43769) or equivalent, onto NEW output nut and output shaft. Tighten nut to specification. See TORQUE SPECIFICATIONS .
  3. Using a wrench on selector shaft flats, rotate shaft to fullest clockwise position. See Figure. Rotate selector shaft counterclockwise by 2 detents. Ensure park pawl is disengaged.
scientia non olet · About LEMON Manuals