LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 471 (Automatic Transmission - Overhaul - ALLISON) >> Component Disassembly & Reassembly >> Rotating Clutch Module >> Rotating Clutch Housing Bushing Replacement

Rotating Clutch Housing Bushing Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, 2003 Chevrolet Cab & Chassis Silverado, and 2002 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Gently tap bushing through large open side of rotating clutch housing until bushing is dislodged out smaller opening. Remove any nicks and burrs with crocus cloth. Position rotating clutch housing on a press so front of housing is facing upward.
  2. If bushing is being installed by hand (a press is preferred), install large end of Rotating Clutch Bushing Installer (J-43778) or equivalent, onto Universal Driver (J-8092) or equivalent. Install NEW bushing onto bushing installer tool. Drive or press the NEW bushing into rotating clutch housing. Ensure bushing is installed flush to .010" (.25 mm) below rotating clutch housing surface.
scientia non olet · About LEMON Manuals