LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 471 (Automatic Transmission - Overhaul - ALLISON) >> Component Disassembly & Reassembly >> P1 Planetary Module >> P1 Planetary Carrier Bushing Replacement

P1 Planetary Carrier Bushing Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, 2003 Chevrolet Cab & Chassis Silverado, and 2002 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The preferred method for removing/installing P1 carrier bushing is to use a P1 Bushing Remover/Installer (J-43781) or equivalent, and a press. If a press is not available, use bushing remover/installer tool and a Universal Driver (J-8092) or equivalent.
  1. Position P1 planetary carrier on the press with the external splines upward. If bushing will be removed without a press, install short end of P1 Bushing Remover/Installer (J-43781) or equivalent, onto Universal Driver (J-8092) or equivalent. Press or drive bushing out bottom side of carrier.
  2. If bushing will be installed by hand, install long end of bushing remover/installer tool onto universal drive. Install NEW bushing into remover/installer tool. Press or drive bushing into carrier from top side, until remover/installer tool seats.
scientia non olet · About LEMON Manuals