LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 471 (Automatic Transmission - Overhaul - ALLISON) >> Component Disassembly & Reassembly >> Front Support Assembly >> Reassembly

Front Support Assembly: Reassembly

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, 2003 Chevrolet Cab & Chassis Silverado, and 2002 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Ensure all pins and clips are seated below sealing or mating surface after installation of valves and stops to prevent damage to transmission.
  1. Position front support assembly on workbench so rear of assembly is facing downward. Install converter flow valve, spring and stop. See Figure and Figure .
  2. Assemble Spring Compressor Adapter (J-24459-5) or equivalent, and Main/Lube/Converter Relief Valve Spring Compressor (J-43770) or equivalent. See Figure. Install the valve spring compressor onto the front support with 2 retaining bolts. See Figure.
  3. Align slot of spring compressor adapter with retainer pin. Compress spring until stop is past pin hole, then install retainer pin. See Figure. Remove valve spring compressor.
  4. Install converter relief valve and spring. Using Valve Spring Compressor (J-43773) or equivalent, compress spring. Install retaining clip. See Figure.
  5. Install lube regulator valve and spring. Install a NEW "O" ring onto lube regulator stop, then install stop. Align slot of spring compressor adapter tool with retainer pin. Using adapter, compress spring until stop is past pin hole. Install retainer pin. See Figure.
  6. Install clutch backfill valve and spring. Using valve spring compressor tool, compress spring and install retaining clip. See Figure.
  7. Install main regulator valve, spring and stop. Assemble spring compressor adapter and valve spring compressor tool assembly. Install tool assembly onto front support with 2 retaining bolts. See Figure.
  8. Align slot of spring compressor adapter with retainer pin. Compress spring until stop is past pin hole, then install retainer pin. See Figure. Remove tool assembly.
scientia non olet · About LEMON Manuals