LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 461 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Air Bag Modules >> Removal & Installation (Driver-side)

Removal & Installation (Driver-side)

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Turn steering wheel 90 degrees from straight ahead position to gain access to rear steering wheel holes. Insert flat-blade screwdriver into each hole and push on leaf springs to release driver-side air bag module retaining pins. See Fig 1. Turn steering wheel 180 degrees to access remaining holes. Pull air bag module away from steering wheel.
  3. Disconnect driver-side air bag module wire harness from clips on air bag module and steering wheel. Remove Connector Position Assurance (CPA) clip from driver-side air bag module. Disconnect driver-side air bag module connector. Remove driver-side air bag module.
  4. To install, reverse removal procedure. Ensure leaf springs engage pins on driver-side air bag module. Activate air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying Driver-side Air Bag Module
G98D13576Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals