LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 431 (Engine Mechanical - 6.5L (On-Vehicle)) >> Removal & Installation >> Engine Lift Brackets >> Installation

Engine Lift Brackets: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine lift bracket to the engine block. Install the engine lift bracket bolts to the cylinder head and tighten the bolts to specifications. See TORQUE SPECIFICATIONS . Install the power steering pump to the engine lift bracket. Tighten all fasteners to specifications. See TORQUE SPECIFICATIONS .
  2. Install the thermostat housing crossover to the cylinder heads. See THERMOSTAT HOUSING CROSSOVER . Install the A/C compressor to the engine lift bracket. Install the idler pulley assembly to the engine lift bracket. See DRIVE BELT IDLER PULLEY . Install the auxiliary generator (if equipped) to the engine lift bracket.
  3. Install the engine cooling fan to the vehicle. Tighten all fasteners to specifications. See TORQUE SPECIFICATIONS . Install the drive belt on the pulleys. See DRIVE BELT . Install the fan shroud in the vehicle. Tighten all fasteners to specifications. See TORQUE SPECIFICATIONS . Refill the cooling system. See DRAINING & FILLING COOLING SYSTEM .
  4. If removed, install the rear A/C pipe to the compressor. Tighten compressor hose fittings to specifications. See TORQUE SPECIFICATIONS . Recharge the A/C system. See RECOVERY/EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in HVAC. Connect both the battery negative cables to the batteries and tighten to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals