Removal & Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Crankcase Depression Regulator (CDR) valve is replaced as an assembly. Replace the hose, the pipe, and the grommet as required, if the inspection indicates cracks or decay.
Remove the engine cover. Remove the nut and the bracket for retaining the CDR valve. Remove the hose clamp at the CDR valve. Disconnect the hose from the CDR valve. See Fig 1. Remove the CDR valve by pulling straight up. Install the CDR valve into the valve cover. Connect the hose. Install the clamp and tighten to specifications. See TORQUE SPECIFICATIONS . Install the CDR retaining bracket and nut. Tighten nut to specifications. See TORQUE SPECIFICATIONS . Install the engine cover.