LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Steering Wheel & Steering Column) >> Repair Instructions >> Tilt Spring Replacement - Steering Column >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Tilting Column To Up Position
    GM293245Courtesy of GENERAL MOTORS CORP.
  1. Use the tilt lever to tilt the column to the UP position.
    2. Fig 2: Identifying Spring Guide Components
    GM293249Courtesy of GENERAL MOTORS CORP.
  2. Install the spring guide (1) into the tilt spring (2).
    3. Fig 3: Installing Tilt Spring Onto The Steering Column Support Assembly
    GM293251Courtesy of GENERAL MOTORS CORP.
  3. Install the tilt spring (1) onto the steering column support assembly (2) and onto the steering column tilt head assembly by using the following procedure:
    1. Install the tilt spring (1) onto the steering column tilt head assembly.
    2. Install the tilt spring (1) onto the post on the steering column support assembly (2).
  4. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .
scientia non olet · About LEMON Manuals