Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Steering Column Assembly

Courtesy of GENERAL MOTORS CORP.

Install the steering column to the vehicle and connect it to the intermediate shaft.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the steering column mounting nuts.
Tighten: Tighten the steering column mounting nuts to 27 N.m (20 lb ft).

Fig 2: View Of Steering Column & Upper Intermediate Shaft

Courtesy of GENERAL MOTORS CORP.

Install the intermediate shaft bolt to the steering column.
Tighten: Tighten the intermediate shaft bolt to 50 N.m (37 lb ft).

Fig 3: Removing/Installing Left Side HVAC Floor Air Outlet Duct

Courtesy of GENERAL MOTORS CORP.

Connect the LH HVAC floor duct temperature sensor and install the LH HVAC floor duct (1).
Install the LH HVAC floor duct mounting screw (2).
Tighten: Tighten the LH HVAC floor duct mounting screw (2) to 1.9 N.m (17 lb in).

Fig 4: Body Wiring Harness Connector & Steering Column Lower Bracket

Courtesy of GENERAL MOTORS CORP.

Connect the body wiring harness connector to the steering column lower bracket.
Connect the steering column electrical connector to the vehicle wiring harness.
Tighten: Tighten the steering column electrical connector center screw to 6 N.m (4 lb ft).
Install the knee bolster. Refer to KNEE BOLSTER REPLACEMENT .
Install the steering wheel. Refer to Steering Wheel Replacement .
Unlock the steering column by removing J 42640 from the steering column lower trim cover access hole.

Fig 5: Identifying J 42640
Courtesy of GENERAL MOTORS CORP.
Enable the SIR system. Refer to ACTIVATING SYSTEM .