LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction, Turn Signal, and Hazard Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The electrical contact on the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.
    Fig 1: Removing/Installing Turn Signal Switch Assembly
    GM761439Courtesy of GENERAL MOTORS CORP.
  1. Install the turn signal and multifunction switch assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure by using 2 pan head tapping screws.

    Tighten

    • Tighten the screw on the top of the column to 3 N.m (27 lb in).
    • Tighten the screw in the front to 7 N.m (62 lb in).
  3. Connect the connectors to the turn signal and multifunction switch assembly.
  4. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  5. Enable the inflatable restraint steering wheel module. Refer to ACTIVATING SYSTEM .
scientia non olet · About LEMON Manuals