Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Horn Contact Plate, Steering Wheel & Screws

Courtesy of GENERAL MOTORS CORP.

Install the horn switch (2) to the steering wheel (3).

NOTE: Refer to FASTENER NOTICE .

Connect the horn contact plate (2) captured screws (1,4) to the steering wheel (3).
Tighten: Tighten the horn contact plate captured screws to 5.5 N.m (50 lb in).

Fig 2: View Of Horn Plunger At Steering Column

Courtesy of GENERAL MOTORS CORP.

Install the horn plunger to the steering column.
Install the inflator module. Refer to AIR BAG MODULES .
Enable the SIR system. Refer to ACTIVATING SYSTEM .