LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Engine Mechanical - 3.0L) >> Removal & Installation >> Engine Coolant Crossover Pipe >> Removal

Engine Coolant Crossover Pipe: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue and 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Lift and support the intake manifold. Refer REMOVAL .
  3. Drain the engine coolant. Refer to DRAINING THE COOLING SYSTEM .
  4. Disconnect the electrical connector at the coolant bridge.
  5. Disconnect the coolant hoses at the coolant bridge.
    6. Fig 1: Coolant Bridge Bolts
    G00564386Courtesy of GENERAL MOTORS CORP.
  6. Remove the coolant bridge bolts.
  7. Remove the coolant bridge.
  8. Remove all 4 seals at the coolant bridge.
scientia non olet · About LEMON Manuals