LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 370 (Engine Control System - Self-Diagnostics - 4.2L) >> Diagnostic Tests >> DTC P0507: Idle Control System - High Rpm >> Diagnostic Procedures

Diagnostic Procedures

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Diagnostic System Check - Engine Controls? If yes, go to next step. If no, see DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS  under SELF-DIAGNOSTIC SYSTEM.
  2. Start engine. Command engine speed up to 1500 RPM, down to 500 RPM, and up to 1500 RPM with scan tool. Exit the RPM control function. Does the engine speed correspond, within 100 RPM, with each command? If yes, problem is intermittent. See INTERMITTENTS in TROUBLE SHOOTING - NO CODES - 4.2L BRAVADA, ENVOY, ENVOY XL, TRAILBLAZER & TRAILBLAZER EXT article. If no, go to next step.
  3. Inspect for the following conditions:
    • Vacuum leaks.
    • Excessive deposits in the throttle body.
    • A faulty PCV valve.

    After inspection or repair, go to next step.

  4. Clear the DTCs with scan tool. Turn ignition off for 30 seconds. Start engine. Operate vehicle within the Conditions For Running DTC. See CONDITIONS FOR RUNNING DTC . Does the DTC run and pass? If yes, go to next step. If no, go to step  2.
  5. Observe the stored information, Capture Info with scan tool. Does scan tool display any DTCs that you have not diagnosed? If yes, see DIAGNOSTIC TROUBLE CODE DEFINITIONS . If no, system is okay.
scientia non olet · About LEMON Manuals