LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 348 (Servicing - A/T (VT25-E)) >> Removal & Installation >> Transaxle Range Switch >> Installation (Using New Switch)

Installation (Using New Switch)

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure transaxle manual shaft is in Neutral position.
  2. Align flats on transaxle shift shaft with flats on transaxle range switch and install switch. See Figure .
  3. Tighten transaxle range switch bolts to specification. See TORQUE SPECIFICATIONS  .
  4. Install transaxle range switch lever and nut then tighten to specification. See TORQUE SPECIFICATIONS  .
  5. Connect transaxle range switch harness connectors.
  6. Install control cable assembly to transaxle range switch lever. Install battery tray bracket. Position battery tray bracket and tighten screws to specification. See TORQUE SPECIFICATIONS  .
  7. Install battery cooling box. See BATTERY COOLING BOX  .
  8. Insert battery and tighten battery hold-down screw to specification. Connect positive battery cable to battery and tighten screws to specification. Connect negative battery cable to battery and tighten screws to specification. Install battery cooling box cover and tighten screws to specification. See TORQUE SPECIFICATIONS  .
  9. Reprogram radio stations. Adjust transaxle range switch. See TRANSAXLE RANGE SWITCH  under ADJUSTMENTS. After adjusting switch, verify engine starts only in Park or Neutral position. If engine starts in any other position, readjust switch.
scientia non olet · About LEMON Manuals