Transaxle Mount (Rear): Installation
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear transaxle mount into the rear transaxle mounting bracket.
- Secure the rear transaxle mount with the through bolt. DO NOT fully tighten the through bolt.
- Raise and suitably support the vehicle.
- Install the 3 nuts and one bolt to secure the rear transaxle mount to the transmission support. See Figure . Tighten the nuts and bolt to specification. See TORQUE SPECIFICATIONS .
- Lower the vehicle.
- Tighten the through bolt. See Figure . Tighten the through bolt to specification. See TORQUE SPECIFICATIONS .
- Remove the engine support fixture from the engine.