LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 247 (Automatic Transmission Removal & Installation - (Fwd)) >> Removal & Installation >> Transaxle Mount (Front) >> Installation

Transaxle Mount (Front): Installation

WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the front transaxle bracket and bolts. Tighten the transaxle bracket bolts to specification. See TORQUE SPECIFICATIONS  .
  2. Install the insulator to the mount bracket.
  3. Install the front transaxle mount through bolt. See Figure . Tighten the transaxle mount through bolt to specification. See TORQUE SPECIFICATIONS  .
  4. Install the 2 bolts to the front transaxle mount. Tighten the front transaxle mount bolts to specification. See TORQUE SPECIFICATIONS  .
  5. Install the left hand splash shield.
  6. Install the right hand splash shield.
  7. Lower the vehicle.
  8. Remove the engine support fixture.
scientia non olet · About LEMON Manuals