LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Disc Brakes) >> Removal & Installation >> Brake Rotor >> Installation (Rear - Dual Wheels)

Installation (Rear - Dual Wheels)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the hub and the rotor, if applicable.
  2. Press the wheel studs into the hub and rotor assembly.
  3. Install the hub and rotor assembly. See HUB & ROTOR ASSEMBLY under REMOVAL & INSTALLATION in appropriate RING GEARS article in DRIVELINE/AXLES.
  4. Install the tire and wheel assembly. Tighten to specification. See TORQUE SPECIFICATIONS .
  5. Lower the vehicle.
  6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
  7. Slowly release the brake pedal.
  8. Wait 15 seconds, then repeat steps  5- 6 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  9. Fill the master cylinder reservoir to the proper level with clean brake fluid. See MASTER CYLINDER RESERVOIR FILLING  under BLEEDING BRAKE SYSTEM.
scientia non olet · About LEMON Manuals