Master Cylinder Reservoir Filling

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Brake fluid may irritate eyes and skin. In case of eye contact, rinse thoroughly with water. In case of skin contact, wash with soap and water. In case of ingestion, consult a physician immediately.

CAUTION: Avoid spilling brake fluid onto painted surfaces, electrical connections, wiring, or cables. Brake fluid will damage painted surfaces and cause corrosion to electrical components. If any brake fluid comes in contact with painted surfaces, immediately flush the area with water. If any brake fluid comes in contact with electrical connections, wiring, or cables, use a clean shop cloth to wipe away the fluid.

CAUTION: When adding fluid to the brake master cylinder reservoir, use only Delco Supreme 11® (GM P/N 12377967), or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container. The use of any type of fluid other than the recommended type of brake fluid, may cause contamination which could result in damage to the internal rubber seals and/or rubber linings of hydraulic brake system components.

Visually inspect the brake fluid level through the brake master cylinder reservoir.
If the brake fluid level is at or below the half-full point during routine fluid checks, the brake system should be inspected for wear and possible brake fluid leaks.
If the brake fluid level is at or below the half-full point during routine fluid checks, and an inspection of the brake system did not reveal wear or brake fluid leaks, the brake fluid may be topped-off up to the maximum-fill level.
If brake system service was just completed, the brake fluid may be topped-off up to the maximum-fill level.
If the brake fluid level is above the half-full point, adding brake fluid is not recommended under normal conditions.
If brake fluid is to be added to the master cylinder reservoir, clean the outside of the reservoir on and around the reservoir cap prior to removing the cap and diaphragm. Use only Delco Supreme 11®, or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.