LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 2002 (Hybrid Cooling System - 3.6L (Hp5)) >> Repair Instructions >> Generator Control Module Coolant Pump Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the generator control module cooling system. Refer to Generator Control Module Cooling System Draining and Filling 
  2. Remove the left headlamp. Refer to Headlamp Replacement
  3. Fig 1: Surge Tank Outlet Hose
    GM2142903Courtesy of GENERAL MOTORS CORP.
  4. Using J 38185:  Hose Clamp Pliers reposition the generator control module coolant pump hose clamp (1).
  5. Remove the generator control module coolant pump hose (2) from the radiator surge tank air separator.
  6. Remove the underhood junction block. Refer to Underhood Electrical Center or Junction Block Replacement (HP5)
  7. Remove the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement (HP5)
  8. Fig 2: Generator Control Module Coolant Pump Hose
    GM2159160Courtesy of GENERAL MOTORS CORP.
  9. Using J 38185:  Hose Clamp Pliers reposition the generator control module coolant pump hose clamp (1).
  10. Remove the generator control module coolant pump hose (3) from the drive motor generator control module coolant pump.
  11. Remove the generator control module coolant pump hose fastener (2) from the cooling fan shroud.
  12. Remove the generator control module coolant pump hose (3) from the vehicle.